Setting the Timer. If you are in any doubt regarding this matter, consult an electrician. Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations that are subject to vibrations or excessive dust, heat, cold or moisture. If a foreign object should get into the unit, contact your dealer or service agency. Use a clean, dry cloth. During playback, the disc rotates at high speed.
Do NOT lift or move the unit during playback. Doing so could damage the disc. When changing the location of placement or packing the unit for transportation, be sure to remove the disc and close the disc compartment cover. Then, press the power switch to turn the power off, and disconnect the power cord. Moving this unit with a disc loaded could result in damage to this unit. If the surface of the unit gets dirty, wipe with a soft cloth or use diluted neutral cleaning liquid.
Be sure to remove any fluid completely. Do not use thinner, benzene or alcohol as they could damage the surface of the unit. When the unit or a disc is moved from a cold to a warm place, or used after a sudden temperature change, there is a danger of condensation. Vapour in the air could condense on the internal mechanism, making correct operation impossible.
To prevent this, or if this occurs, leave the unit for one or two hours with the power turned on. The unit will stabilize at the temperature of its surroundings. If you use such discs in this unit, TEAC Corporation and its subsidiaries cannot be responsible for any consequences or guarantee the quality of reproduction.
If you experience problems with such nonstandard discs, you should contact the producers of the disc. Only one side of Compact Discs can be played and recorded. Never clean a disc using a circular motion. Long exposure to high temperatures will warp a disc. It is important that they are stored in a location where direct sunlight does not shine on them and that is away from heat sources such as radiators and heat-generating electrical devices.
Never use a ballpoint or hard-tipped pen, because this could damage the recorded side. Using commercially-available CD stabilizers with this unit will damage the mechanisms and cause them to malfunction. They could damage the unit.
Only the first session can be played back. This unit cannot play discs if the session has not been closed. To prevent hum and noise, do not bundle the connection cords. You can connect a portable audio player to this jack. When using the PHONES jack of an audio player, you must also adjust the volume of that audio player or you might hear no sound from this unit. In this case, reduce the volume of the audio player until the distortion stops and then adjust the volume level of this unit to a comfortable listening level.
While in FM mode, tune in to an FM station and extend the lead to find the best position for reception. This antenna may need to be repositioned if you move your unit to a new location. This battery supplies backup power to the builtin clock and memory when the unit is temporarily disconnected from the AC outlet.
Push the other end of the cover to open the compartment. Insert a CR lithium-ion battery with the positive. If the clock begins to indicate the wrong time, replace the battery with a new one. Disc compartment cover. Remote sensor. Speakers stereo. Number buttons. The included remote control allows the main unit to be operated from a distance. When operating the remote control, point it towards the remote sensor on the front panel of the unit. Likewise, other products might also operate incorrectly.
Remove the battery compartment cover. If the maximum distance from which the remote control can operate the main unit decreases, the batteries are probably exhausted. In this case, replace the batteries with new ones.
Never use different types of batteries together. Refer to the precautions on their labels. If they do leak, wipe away the leakage inside the battery compartment and replace the batteries with new ones. Push it again to restore regular brightness.
This function also works in standby mode. Each press of the SLEEP button changes the amount of time between 15 and 90 minutes until the unit automatically switches to Standby mode. No buttons will work during loading. Do not open the disc compartment cover when a disc is playing. Doing so is dangerous because the disc will pop out. Wait until the total number of the files and the total number of folders on the USB memory are displayed.
During playback, press a SKIP. When the unit is stopped, press a SKIP. During playback, hold down a SKIP. The program is retained in memory until you open the disc compartment cover or the power is interrupted. If you press a SKIP. If you press the. Release it when you find the station that you want. Select this mode in areas where FM stereo reception is weak.
Reception is forced to mono, reducing unwanted noise. If the power supply is interrupted and the battery dies, the settings kept in memory clock, preset stations, timer setting will be erased. The station is stored. To store more stations, repeat steps to. The Radio Data System RDS is a broadcasting service that allows stations to send additional information along with regular radio programme signals.
When you select RT, up to 64 characters of information transmitted by the station will be displayed. If you tune in to an RDS station broadcasting incorrect CT data, the clock could be set incorrectly, and this could affect timer operation. To turn the CT mode on or off, press and hold the INFO button for more than 2 seconds, then turn the volume knob to select on or off. Then press the SKIP buttons repeatedly to select the desired programme type. When using the PHONES jack of an audio player, you must adjust the volume of the audio player or you might not hear any sound from this unit.
Do not turn the volume of the audio player up too high, however, because doing so might cause the sound from this unit to be distorted. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.
This will prevent damage to the product due to lightning and power-line surges. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. Never spill liquid of any kind on the product. Refer all servicing to qualified service personnel.
Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.
Unauthorized substitutions may result in fire, electric shock, or other hazards. If you are in any doubt regarding this matter, consult an electrician. Avoid placing it in direct sunlight or close to a source of heat.
Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture. If a foreign object should get into the set, contact your dealer or service agency.
Use a clean, dry cloth. During playback, the disc rotates at high speed. Do NOT lift or move the unit during playback. Doing so may damage the disc. When changing places of installation or packing the unit for moving, be sure to remove the disc. Then, press the power switch to turn the power off, and disconnect the power cord.
Moving this unit with the disc loaded may result in damage to this unit. When the unit or a disc is moved from a cold to a warm place, or used after a sudden temperature change, there is a danger of condensation; vapor in the air could condense on the internal mechanism, making correct operation impossible. To prevent this, or if this occurs, leave the unit for one or two hours with the power turned on.
The unit will stabilize at the temperature of its surroundings. If the surface of the unit gets dirty, wipe with a soft cloth or use diluted mild soap liquid. Be sure to remove any excess completely. Do not use thinner, benzine or alcohol as they may damage the surface of the unit. Si un objet rentre dans l'appareil, contacter votre revendeur. Utiliser un chiffon propre et sec. En effet, vous risqueriez d'endommager ce disque.
Ne pas utiliser de diluant, de benzine ou d'alcool car ils risquent d'endommager la surface de l'appareil. Compact discs can be played or recorded only on one side. Do not wipe in a circular motion :. Such chemicals will do irreparable damage to the disc's plastic surface. Long exposure to high temperatures will warp the disc. It is important that they are not stored in a location where direct sunlight will fall on them, and which is away from sources of heat such as radiators or heatgenerating electrical devices.
Never use a ball-point or hard-tipped pen, as this may cause damage to the recorded side. Using commercially available CD stabilizers with this unit will damage the mechanisms and cause them to malfunction. CDs of this sort can damage the unit:. The provided Remote Control Unit allows the unit to be operated from a distance. Conversely, the other appliances may operate incorrectly. If the distance required between the remote control unit and main unit decreases, the batteries are exhausted.
In this case replace the batteries with new ones. Never use different types of batteries together. Refer to the precautions on their labels. If they leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones. Dans la situation inverse, les autres apaareils peuvent ne pas bien fonctionner.
Dans ce cas, remplacer les piles par des nouvelles. Si elles coulent, essuyer le liquide dans le compartiment des piles et remplacer les piles par des neuves. Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password?
0コメント